Modifying a Group

Scenarios

Modify a group on COC.

Procedure

1. Log in to COC.
2. In the navigation pane, choose Resources > Application and Resource Management. On the displayed page, click the Applications tab, choose a desired group in the resource tree on the left, and click .
   Figure 1 Modifying a group
   

3. Set parameters in the Modify Group drawer by referring to Table 1 and click OK.

   Table 1 Parameters for modifying a group

   Parameter	Description	Example Value
   Group	(Mandatory) Group of the component you created. Enter a valid group name.	Test Group
   Resource Association Method	(Mandatory) Method that is used to associate resources with the group you created. There are two association methods: manual association and intelligent association. Manual: You can manually associate resources with the group you created for unified management. Intelligent: You can add all resources with the same tag in an enterprise project to a resource group.	Manual
   Enterprise Project	(Mandatory) Enterprise project. This parameter is displayed when the resource association mode is intelligent association.	/
   Tag Key	(Mandatory) This parameter is displayed if the intelligent resource association method is used.	testKey
   Tag Value	(Optional) This parameter is displayed if the intelligent resource association method is used.	testValue
   Associate APM Environment	(Optional) Configure the application, component, and environment of the APM service corresponding to the group. APM service performance information can be obtained through this field during fault diagnosis.	/