MQTT Client Access

Connection Configuration Parameters

The table below describes the connection address and connection authentication parameters for the MQTT client to connect to the platform.

• MQTT access domain name

  It is automatically generated for each account. Log in to the IoTDA console to obtain it on the Access Details page.

  

• Port: 8883
• Client identity authentication parameters

  clientId: The value must be globally unique. You are advised to use username.

  username ="accessKey=${accessKey}|timestamp=${timestamp}|instanceId=${instanceId}"

  password ="${accessCode}"

  Parameter	Mandatory	Description
  ${accessKey}	Yes	An accessKey can be used to establish a maximum of 10 concurrent connections. When establishing a connection for the first time, preset the parameter by following the instructions provided in Obtaining the AMQP Access Credential.
  ${timestamp}	Yes	Current time. The value is a 13-digit timestamp, accurate to milliseconds. The server verifies the client timestamp. There is a 5-minute difference between the client timestamp and server timestamp.
  instanceId	Optional	Instance ID. This parameter is mandatory when multiple instances of the Standard Edition are purchased in the same region. For details, see Viewing Instance Details.
  ${accessCode}	Yes	The value can contain a maximum of 256 characters.

Obtaining the MQTT Access Credential

An access credential is required for an application that uses MQTT to connect to the platform for data forwarding. If you use an access credential for the first time or forget it, preset an access credential. You can call the API for generating an access credential or use the console to preset an access credential. The procedure for using the console to generate an access credential is as follows:

1. Access the IoTDA service page and click Access Console.
2. Choose Rules > Data Forwarding. The Rule List page is displayed.
   Figure 1 Rule list
   

3. Click View. (If no rule exists, create one.) On the rule details page that is displayed, click the Set Forwarding Target tab.
   Figure 2 Setting the forwarding target
   

4. Click Add. On the Add Forwarding Target page that is displayed, select MQTT message queue for Forwarding Target, and click Preset Access Credential to preset the access code and access key.
   Figure 3 Presetting an access credential

   

   

   If you already have an access credential, the accessKey cannot be used after you preset the access credential again.

Receiving Push Messages

After a connection is established between the client and the platform, subscribe to the MQTT topic in the data forwarding rule. When a device reports data and the rule is triggered, the platform pushes the data to the MQTT client.