Help Center/ Atlas 500 Application/ Software Development Guide/ Configuring the Atlas 500/ Logging In to and Using the Atlas 500 CLI
Updated on 2022-03-13 GMT+08:00
View PDF
Share

Logging In to and Using the Atlas 500 CLI

You can run commands on the Atlas 500 CLI to manage the Atlas 500. You can log in to the Atlas 500 CLI using either of the following:

  • SSH
  • serial port

Logging In to the OS Using SSH

  1. Prepare a PC installed with SSH client software (such as PuTTY and MobaXterm).
  2. Connect the PC and GE port 1 of the Atlas 500 to the same LAN, or use a network cable to directly connect the PC to the Atlas 500.
  3. On the PC, ping the Atlas 500 IP address to check whether the network between the Atlas 500 and the PC is connected.
  4. Start the SSH client software on the PC, set parameters, and log in to the Atlas 500.

    Example:

    • Host Name (or IP address): IP address of the Atlas 500. The default IP address of the Atlas 500 is 192.168.2.111.
    • Port: The default value is 22.
    • Connection type (or protocol): Select SSH.
    • Username: Set it to admin.
    • Password: The default password of admin is Huawei12#$.

      After setting the parameters, start the connection and log in to the Atlas 500 OS.

  5. Access the Atlas 500 CLI.

    The host name of the login device is displayed on the left of the prompt.

  6. Run an Atlas 500 CLI command.

    For details about the Atlas 500 CLI commands and their instructions, see "CLI" in the Atlas 500 Intelligent Edge System (V2.2.200.010 or Later) User Guide (Models 3000, 3010).

Logging In to the OS over a Serial Port

  1. Prepare a PC with a serial port, install the serial port client software (PuTTY or MobaXterm) on the PC, and prepare a Phoenix connector-to-serial cable.
  2. Connect the male Phoenix connector to the female Phoenix connector on the rear panel of the Atlas 500, and connect the serial cable to the PC. Locate the female Phoenix connector on the rear panel of the Atlas 500 by referring to "Rear Panel" in the Atlas 500 AI Edge Station User Guide (Models 3000, 3010).
  3. Start the serial port client software and set login parameters.

    Example:

    • Serial Line to connect to: COMn
    • Speed (baud): 115200
    • Data bits: 8
    • Stop bits: 1
    • Parity: None
    • Flow control: None

    In COMN, N indicates the serial port number, and the value is an integer.

    After the parameters are set, start the connection.

  4. Enter the user name and password.

    The default user name and password of the Atlas 500 are admin and Huawei12#$, respectively.

  5. Access the Atlas 500 CLI.

    The host name of the login device is displayed on the left of the prompt.

  6. Run an Atlas 500 CLI command.

    For details about the Atlas 500 CLI commands and their instructions, see "CLI" in the Atlas 500 Intelligent Edge System (V2.2.200.010 or Later) User Guide (Models 3000, 3010).