Help Center/ Atlas 500 Application/ Software Development Guide/ Configuring the Atlas 500/ Obtaining a PC

Updated on 2022-03-13 GMT+08:00

View PDF

Obtaining a PC

Obtain a PC for accessing the IES and CLI of the Atlas 500 and configure network data to enable communication between the PC and the Atlas 500.

Add an IP address in 192.168.2.xxx for the PC, set the subnet mask to 255.255.255.0 and the gateway address to 192.168.2.1.
Connect GE port 1 of the Atlas 500 and the PC network port using an RJ45 network cable.
On the PC, run the ping Atlas 500 IP address command to check whether the communication between the Atlas 500 and the PC is successful.

Parent topic: Configuring the Atlas 500

Previous topic: Powering On an Atlas 500

Next topic: Logging In to the Atlas IES

Feedback

Was this page helpful?

Helpful Not helpful

Provide feedback

Thank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.

The system is busy. Please try again later.

Which of the following issues have you encountered?

Content is inconsistent with the product UI

Unclear descriptions

Lack of examples or code

Incorrect steps

Can't find what I need

Lack of best practices

Feedback (optional)

0/500

Select at least one type of issue, and enter your comments or suggestions.

Enter a maximum of 500 characters.

Submit Cancel

For any further questions, feel free to contact us through the chatbot.