SAVEPOINT

Function

SAVEPOINT establishes a new savepoint within the current transaction.

A savepoint is a special mark inside a transaction that rolls back all commands that are executed after the savepoint was established, restoring the transaction state to what it was at the time of the savepoint.

Precautions

Use ROLLBACK TO SAVEPOINT to roll back to a savepoint. Use RELEASE SAVEPOINT to destroy a savepoint but keep the effects of the commands executed after the savepoint was established.
Savepoints can only be established when inside a transaction block. There can be multiple savepoints defined within a transaction.
SAVEPOINT cannot be used for functions, anonymous blocks, or stored procedures.
In the case of an unexpected termination of a distributed thread or process caused by a node or connection failure, or of an error caused by the inconsistency between source and destination table structures in a COPY FROM operation, the transaction cannot be rolled back to the established savepoint. Instead, the entire transaction will be rolled back.
According to the SQL standard, a savepoint is destroyed automatically when another savepoint with the same name is established. In GaussDB(DWS), old savepoints are kept, though only the most recent one will be used for rollback or release. Releasing the newer savepoint with RELEASE SAVEPOINT will cause the older one to again become accessible to ROLLBACK TO SAVEPOINT and RELEASE SAVEPOINT. Except for this, SAVEPOINT is fully SQL conforming.

Syntax

    
         SAVEPOINT savepoint_name;

Parameter Description

savepoint_name

Specifies the name of a new savepoint.

Examples

Create a savepoint and undo all commands executed after the savepoint is created:

      
           START TRANSACTION;
CREATE TABLE IF NOT EXISTS table1 (a int,b int);
INSERT INTO table1 VALUES (1);
SAVEPOINT my_savepoint;
INSERT INTO table1 VALUES (2);
ROLLBACK TO SAVEPOINT my_savepoint;
INSERT INTO table1 VALUES (3);
COMMIT;

Query the table content, which should contain 1 and 3 but not 2, because 2 has been rolled back.

Create and then destroy a savepoint.

      
           START TRANSACTION;
INSERT INTO table1 VALUES (3);
SAVEPOINT my_savepoint;
INSERT INTO table1 VALUES (4);
RELEASE SAVEPOINT my_savepoint;
COMMIT;