Updated on 2024-05-29 GMT+08:00
Step 3: Deploy an Application
This section describes how to deploy an application on a BMS.
Install and Start Nginx
- Run the yum install nginx command to install Nginx and enter y as prompted.
If the information shown in the following figure is displayed, Nginx is installed successfully.
Huawei Cloud provides free yum repositories, and the NTP and DNS services.
- Enter systemctl start nginx.service to start Nginx.
This command applies to CentOS 7.4 64-bit, which is used as an example.
- Enter wget http://127.0.0.1 to test Nginx.
Access the Default Web Page
Open a browser and enter http://BMS EIP in the address box. If the Nginx welcome page is displayed, Nginx is installed successfully.
What is your overall rating for this page?
0
1
2
3
4
5
6
7
8
9
10
Very dissatisfiedVery satisfied
Thank you very much for your feedback. We will continue working to improve the documentation.
The system is busy. Please try again later.
