Help Center/ GaussDB(DWS)/ Management Guide/ Backup and Disaster Recovery/ Snapshots/ Manual Snapshots/ Creating a Manual Snapshot
Updated on 2024-09-05 GMT+08:00
View PDF

Creating a Manual Snapshot

Prerequisites

A cluster snapshot is a complete backup that records point-in-time configuration data and service data of a GaussDB(DWS) cluster. This section describes how to create a snapshot on the Snapshots page to back up cluster data.

A manual snapshot can be created at any time. It will be retained until it is deleted from the GaussDB(DWS) console. Manual snapshots are full backup data, which takes a long time to create.

  • Manual cluster snapshots can be backed up to OBS or NFS.
  • To create a manual snapshot of a cluster, the cluster state must be Available, To be restarted, or Unbalanced. In cluster versions earlier than 8.1.3.101, you can also create a snapshot of a cluster in the Read-only state.

Impact on the System

If a snapshot is being created for a cluster, the cluster cannot be restarted, scaled, its password cannot be reset, and its configurations cannot be modified.

To ensure the integrity of snapshot data, do not write data during snapshot creation.

Procedure

  1. Log in to the GaussDB(DWS) console.
  2. In the navigation pane, choose Management > Snapshot.
  3. In the navigation pane, choose Snapshots. Click Create Snapshot in the upper right corner. Alternatively, choose More > Create Snapshot in the Operation column.
  4. Configure the following snapshot information:

    • Cluster Name: Select a GaussDB(DWS) cluster from the drop-down list. The drop-down list only displays clusters that are in the Available state.
    • Snapshot Name: Enter a snapshot name. The snapshot name must be 4 to 64 characters in length and start with a letter. It is case-insensitive and contains only letters, digits, hyphens (-), and underscores (_).
    • Snapshot Level: Select cluster.
    • Snapshot Description: Enter the snapshot information. This parameter is optional. Snapshot information contains 0 to 256 characters and does not support the following special characters: !<>'=&"

  5. Click Create.

    Task status of the cluster for which you are creating a snapshot is Creating snapshot. The status of the snapshot that is being created is Creating. After the snapshot is created, its status changes to Available.

    If the snapshot size is much greater than that of the data stored in the cluster, the data is possibly labeled with a deletion tag, but is not cleared and reclaimed. In this case, clear the data and recreate a snapshot. For details, see How Can I Clear and Reclaim the Storage Space?

Parent topic: Manual Snapshots