Creating a Custom Route Table
Scenarios
A VPC automatically comes with a default route table. If your default route table cannot meet your service requirements, you can create a custom route table.
Notes and Constraints
By default, the quota for custom route tables is 0. To create custom route tables, apply for a quota increase first.
Procedure
- Go to the route table list page.
- In the upper right corner, click Create Route Table. On the displayed page, configure parameters as prompted.
Table 1 Parameter descriptions Parameter
Description
Example Value
Name
(Mandatory) The name of the route table. The name:- Can contain 1 to 64 characters.
- Can contain letters, digits, underscores (_), hyphens (-), and periods (.).
rtb-001
VPC
(Mandatory) The VPC that the route table is used to control traffic routing. The route table can be associated with the subnets in this VPC.
vpc-001
Description
(Optional) Supplementary information about the route table.
The description can contain a maximum of 255 characters and cannot contain angle brackets (< or >).
-
Route Settings
(Optional) The route information. You can add a route when creating the route table or after the route table is created. For details, see Adding Routes to a Route Table.
You can click to add more routes.
-
- Click OK.
A message is displayed. You can determine whether to associate the route table with subnets immediately. If you want to associate immediately, perform the following operations:
- Click Associate Subnet. The Associated Subnets page is displayed.
- Click Associate Subnet and select the target subnets to be associated.
- Click OK.
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.