Help Center/
Cloud Firewall/
Best Practices/
Configuring a Protection Rule to Protect SNAT Traffic/
Configuring a NAT Protection Rule
Updated on 2025-05-28 GMT+08:00
Configuring a NAT Protection Rule
After verifying the traffic flow, configure protection rules so that the CFW can allow or block traffic accordingly.
Configuring a NAT Protection Rule
- Log in to the management console.
- Click
in the upper left corner of the management console and select a region or project.
- In the navigation pane on the left, click
and choose . The Dashboard page will be displayed.
- (Optional) Switch to another firewall instance. Select a firewall from the drop-down list in the upper left corner of the page.
- In the navigation pane, choose .
- On the Protection Rules tab page, click the NAT sub-tab, and click Add Rule. On the Add Rule page, configure the key parameters as follows:
- Rule Type: NAT
- Direction: SNAT
- Source: Select IP address. Enter a private IP address.
- Destination: Select IP address (and enter a public IP address) or Domain name/Domain name group.
- Application: Any
- Click OK.
Parent topic: Configuring a Protection Rule to Protect SNAT Traffic
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
The system is busy. Please try again later.
For any further questions, feel free to contact us through the chatbot.
Chatbot