Step 1: Create a Protection Group

Scenarios

You can specify two AZs as the source and target AZs, and create a protection group. Then, you can create protected instances and replication pairs in this protection group.

Verify the servers at the production and DR sites before you create a protection group. In this version, only the VPC migration deployment model is supported. Specifically, the servers at the production and DR sites must be in different AZs but in the same VPC.

Figure 1 Creating a protection group

Procedure

1. Log in to the management console.
2. Click Service List and choose Storage > Storage Disaster Recovery Service.

   The Storage Disaster Recovery Service page is displayed.

3. Click Create Protection Group.

   The Create Protection Group page is displayed.

4. Configure the basic information about the protection group listed in Table 1.
   

   Parameters listed in Table 1 are mandatory.

   Table 1 Parameter description

   Parameter	Description	Example Value
   Region	A region is a geographic area where resources used by servers are located. If the region is incorrect, click the drop-down list for correction.	AP-Bangkok
   DR Direction	Production site: Select the AZ of the production site server. DR site: Select the AZ of the DR site server.	Production site: az-01 DR site: az-02
   Deployment Model	Currently, only the VPC migration model is supported. All resources at the production and DR sites belong to the same VPC.	VPC migration
   VPC	Specifies the VPC where the protection group is located.	vpc-test
   Protection Group Name	Enter the protection group name. It is used for group classification and search.	protection_group_001

5. Click Create Now.
6. Click Back to Protection Group List to return to the SDRS homepage and query the protection group status.

   If the protection group is displayed in the Storage Disaster Recovery Service page and its status is Available (), the protection group has been created successfully.