Configuring an Anti-DDoS Protection Policy

Scenarios

You can adjust your Anti-DDoS protection policy after Anti-DDoS is enabled.

Prerequisites

You have obtained credentials for logging in to the management console.

Procedure

1. Log in to the management console.
2. Click in the upper left corner of the management console and select a region.
3. Click the Public IP Addresses tab, locate the row that contains the IP address for which you want to set protection, and click Set Protection in the Operation column.
4. In the Set Protection dialog box, modify the parameters. Table 1 describes the parameters.

   Table 1 Parameter description

   Parameter

   Description

   Protection Settings

   Anti-DDoS scrubs traffic when detecting that the incoming traffic of an IP address exceeds the threshold. The default protection rate is 120 Mbit/s. You can manually set more protection levels. NOTE: If service traffic triggers scrubbing, only attack traffic is intercepted. If service traffic does not trigger scrubbing, no traffic is intercepted. Set this parameter based on the actual service access traffic. You are advised to set a value closest to, but not exceeding, the purchased bandwidth.

5. Click OK to save the settings.