Why Are Garbled Characters Displayed When I Log In to My ECS Using VNC?
Symptom
After I attempt to log in to my Linux ECS using VNC, garbled characters are displayed, as shown in Figure 1.
Possible Causes
The cat command was executed to display a large binary file, leading to garbled characters.
Solution
Log in to the ECS as user root and run the following command for recovery:
reset
The reset command is used to re-initialize the ECS and refresh the terminal display. After the reset command is executed, the garbled characters are cleared and the fault is rectified.
Logins Through the Management Console FAQs
- Why Are Garbled Characters Displayed When I Log In to My ECS Using VNC?
- What Should I Do If the Page Does not Respond After I Log In to an ECS Using VNC and Do Not Perform Any Operation for a Long Period of Time?
- What Should I Do If I Cannot View Data After Logging In to an ECS Using VNC?
- Why Does a Blank Screen Appear After I Attempted to Log In to an ECS Using VNC?
- What Should I Do If Error Code 1006 or 1000 Is Displayed When I Log In to an ECS Through the Management Console?
- Why No Audio File Can Be Properly Played on My Windows ECS Logged In Using VNC?
- How Can I Change the Resolution of a Windows ECS?
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
For any further questions, feel free to contact us through the chatbot.
Chatbotmore