Updated on 2023-07-06 GMT+08:00

Step 3: Configure Security Group Rules

Scenarios

A security group is a collection of access control rules for ECSs and RDS DB instances that have the same security protection requirements and are mutually trusted in a VPC.

This section describes how to create a security group to enable specific IP addresses and ports to access RDS.

When you attempt to connect to an RDS DB instance through an EIP, you need to configure an inbound rule for the security group associated with the DB instance.

Precautions

The default security group rule allows all outgoing data packets. ECSs and RDS DB instances can access each other if they are deployed in the same security group. After a security group is created, you can configure security group rules to control access from and to the DB instances in the security group.

  • By default, you can create a maximum of 500 security group rules.
  • One security group can be associated with only one RDS DB instance.
  • Too many security group rules will increase the first packet latency. You are advised to create a maximum of 50 rules for each security group.
  • To access an RDS DB instance from resources outside the security group, you need to configure an inbound rule for the security group associated with the RDS DB instance.

If you use 0.0.0.0/0, you enable all IP addresses to access RDS DB instances in the security group.

Procedure

  1. Log in to the management console.
  2. Under Network, click Virtual Private Cloud.
  3. In the navigation pane on the left, choose Access Control > Security Groups.
  4. On the Security Groups page, locate the target security group and click Manage Rule in the Operation column.
  5. On the displayed page, click Add Rule.
  6. In the displayed dialog box, set required parameters to add an inbound rule.
  7. Click OK.