Configuring the Parameter Plane Network of Lite Server Nodes

Scenario

The Lite Server task center provides one-click system configuration capabilities, allowing you to quickly configure the parameter plane network settings on the Lite Servers page. To meet basic requirements of training and inference scenarios and improve server performance, you can optimize server parameters, such as the RoCE network uplink port and parameter plane network IP address. In addition, you can perform operations on multiple servers in batches for higher efficiency.

Constraints

• Only Snt9b nodes and Snt9b23 supernodes are supported.
• The NodeTaskHub plug-in is required for the node where the task is to be created. Ensure that the plug-in is installed before task creation. For details, see Managing Lite Server AI Plug-ins.
• Only one task can be executed on a node at the same time. The task cannot be interrupted once started. Plan the task priority.
• Ensure that no services are running on the target node. Services may be interrupted or abnormal during task execution.
• Install the MCU, driver, and firmware for Ascend HDK 23.0.0 or later before starting the task. A preconfigured OS is already installed. If you use a custom OS, ensure that the software has been installed correctly.
• The task requires the Ascend-docker-runtime development kit. This software is pre-installed on the default OS. If you use a custom OS, ensure the software has been installed correctly.

Procedure

1. Log in to the ModelArts console.
2. In the navigation pane on the left, choose Lite Servers under Resource Management. On the displayed page, click the Task Center tab.
   Figure 1 Task center
   

3. Click Create Task in the upper left corner. On the displayed Job Templates page, locate Ascend System Configuration, and click Create Task.
   Figure 2 Task template

   

4. On the Ascend System Configuration page, set Name, Description, Server Model, and Configuration Item, agree to the terms of use, and click Create now.

   Table 1 Parameters for creating a task

   Parameter	Description
   Name	The system automatically generates a task name. You can change the name as required.
   Description	Enter the task description for quick search.
   Server Model	Select a server model and select nodes in the node list. You can search for node information using keywords. Snt9b nodes and Snt9b23 supernodes are supported.
   Configuration Item	Parameter Plane Network Configuration: Configure the RoCE network uplink ports properly and set up the parameter plane network with correct IP addresses, subnet masks, and gateways.

5. View the task execution status in the Task Center tab.
6. Click the task name to access its details page, where you can view the task details.
7. On the task details page, locate the target node and click View Logs in the Operation column. In the displayed window on the right, view the detailed log about task execution.
   Figure 3 Viewing logs