Help Center/ Data Replication Service/ Real-Time Disaster Recovery/ Task Management/ Task Life Cycle/ Resetting a DR Task
Updated on 2024-09-25 GMT+08:00
View PDF
Share

Resetting a DR Task

During the disaster recovery, the DR task may fail due to uncertain causes. This section describes how to reset the failed DR task.

You can reset the failed DR tasks in the following status:

  • DR failure

Prerequisites

You have logged in to the DRS console.

Method 1

  1. In the task list on the Disaster Recovery Management page, locate the target task and click Reset in the Operation column.
  2. In the displayed dialog box, check the DR task again.
  3. After the check is complete and the check success rate is 100%, click Start to submit the DR task again.

Method 2

  1. On the Disaster Recovery Management page, click the target task in the Task Name/ID column.
  2. On the displayed page, click the Disaster Recovery Progress tab, and click Reset in the upper right corner.
  3. Perform 2 to 3.
Parent topic: Task Life Cycle