Help Center> Data Replication Service> Workload Replay> Task Management> Task Life Cycle> Resuming a Replay Task
Updated on 2024-05-09 GMT+08:00
View PDF

Resuming a Replay Task

A fault may occur during the workload replay due to external factors. After the fault is rectified based on the replay log information, you can resume the replay.

You can resume replay tasks in any of the following statuses:

  • Failed
  • Paused
    • If a replay task fails due to non-network problems, the system will automatically resume the task three times by default. If the failure persists, you can resume the task manually.
    • If a replay task fails due to network problems, the system will automatically resume the task until the replay is restored.

Prerequisites

You have logged in to the DRS console.

Procedure

  1. In the task list on the Workload Replay Management page, locate the target task and click Resume in the Operation column.
  2. In the displayed Resume Task dialog box, confirm the task information and click Yes to submit the replay task again.
Parent topic: Task Life Cycle