Managing Tags of a VPC Endpoint

Scenarios

After a VPC endpoint is created, you can view its tags, or add, edit, or delete a tag.

Tags help identify VPC endpoints. You can add 10 tags to each VPC endpoint.

If a predefined tag has been created on TMS, you can directly select the corresponding tag key and value.

If you have configured tag policies for VPC Endpoint, add tags to this VPC endpoint based on the tag policies. If you add a tag that does not comply with the tag policies, VPC endpoints may fail to be created. Contact your administrator to learn more about tag policies.

Add a Tag

Perform the following operations to tag an existing VPC endpoint:

1. Log in to the management console.
2. Click in the upper left corner and select the required region and project.

3. Click Service List and choose Networking > VPC Endpoint.

4. In the VPC endpoint list, locate the VPC endpoint and click in front of the endpoint.

5. On the displayed page, select the Tags tab.
6. Click Add Tag.
7. In the displayed Add Tag dialog box, enter a key and a value.

   If you have configured tag policies for VPC Endpoint, add tags to this VPC endpoint based on the tag policies. If you add a tag that does not comply with the tag policies, VPC endpoints may fail to be created. Contact your administrator to learn more about tag policies.

   Table 1 describes the tag requirements.

   Table 1 Tag requirements for VPC endpoints

   Parameter	Requirement
   Tag key	Cannot be left blank. Must be unique for each resource. Can contain a maximum of 128 characters. Cannot start or end with a space or contain special characters =*<>\,|/
   Tag value	Can be left blank. Can contain a maximum of 255 characters. Cannot start or end with a space or contain special characters =*<>\,|/

8. Click OK.

Edit a Tag

Perform the following operations to edit a tag of a VPC endpoint:

1. Log in to the management console.
2. Click in the upper left corner and select the required region and project.

3. Click Service List and choose Networking > VPC Endpoint.

4. In the VPC endpoint list, locate the VPC endpoint and click in front of the endpoint.

5. On the displayed page, select the Tags tab.
6. In the tag list, locate the tag and click Edit in the Operation column.
7. Enter a new value.
   

   You can only edit tag values.

8. Click OK.

Delete a Tag

You can delete tags added to a VPC endpoint. Deleted tags cannot be restored. Exercise caution when performing this operation.

1. Log in to the management console.
2. Click in the upper left corner and select the required region and project.

3. Click Service List and choose Networking > VPC Endpoint.

4. In the VPC endpoint list, locate the VPC endpoint and click in front of the endpoint.

5. On the displayed page, select the Tags tab.

6. In the tag list, locate the tag and click Delete in the Operation column.
7. Click OK.