ALM-303046943 A Port Detects A PD Whose Current Exceeds the Threshold of the Corresponding Class.
Description
WLAN/4/AP_POE_PD_CLASS_OVER_CURRENT:OID [OID] A port detects a PD whose current exceeds the threshold of the corresponding class. (APMAC=[OPAQUE], APName=[STRING], ApIfIndex=[INTEGER], ApEntityPhysicalName=[OCTET], APID=[INTEGER])
The system detects that overcurrent occurs during PD classification and does not provide power for PDs.
Only the AP4050DN-E, AP4050DN-HD, AP7050DN-E, AP7052DN, AP7152DN, AD9430DN-24, AD9431DN-24X and AD9430DN-12 support this alarm.
Attribute
Alarm ID |
Alarm Severity |
Alarm Type |
---|---|---|
303046943 |
Warning |
Communication alarm |
Parameters
Name |
Meaning |
---|---|
OID |
Indicates the MIB object ID of the alarm. |
APMAC |
Indicates the AP's MAC address. |
APName |
Indicates the AP name. |
ApIfIndex |
Indicates the AP interface index. |
ApEntityPhysicalName |
Indicates the AP interface name. |
APID |
Indicates the AP ID. |
Impact on the System
Services are not affected.
Possible Causes
The PD does not comply with standards.
Procedure
- You can run the poe high-inrush enable (AP system profile view) command in the AP system profile view to configure an interface to allow generation of the high pulse current. Then check whether the alarm is cleared.
- If yes, go to step 4.
- If not, go to step 2.
- Replace the PD and check whether the alarm is cleared.
- If yes, go to step 4.
- If not, go to step 3.
- Contact technical support personnel.
- End.
Related Information
None
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
For any further questions, feel free to contact us through the chatbot.
Chatbot