Updated on 2022-02-24 GMT+08:00

Registered Devices Cannot Connect to the IoT Platform

  1. Run the AT+CGATT=1 command on the module to check whether an error is reported. If yes, perform the following operations:

    • Confirm the status of the NB-IoT card with the NB-IoT network carrier.
    • Confirm the module status with the module manufacturer.

  2. If the device is successfully connected to the network after you run the AT+CGATT=1 command, check whether the IP address and port number of the IoT platform used by the device are correct.

    NOTE:

    The IP address and port number are obtained from the IoT platform service provider. Port 5683 is used for non-encrypted access, and port 5684 is used for encrypted access.

Device Development FAQs

more