Help Center > > FAQs> Passwords and Key Pairs> Passwords> What Should I Do If the System Displays a Message Indicating that the Password Is Incorrect When I Remotely Log In to My ECS?

What Should I Do If the System Displays a Message Indicating that the Password Is Incorrect When I Remotely Log In to My ECS?

Updated at: Mar 17, 2020 GMT+08:00

Solution

Check the network configuration of the ECS and determine whether the fault is caused by a Cloud-Init failure.
  • Verify that port 80 is bypassed in both inbound and outbound directions in the security group to which the target ECS belongs.
    Figure 1 Port 80
  • Verify that DHCP is enabled in the subnet to which the target ECS belongs.
    Figure 2 Checking DHCP status

    After verifying the preceding configurations, restart the ECS, wait for 3 to 5 minutes, and remotely log in to the ECS using a password or key.

Did you find this page helpful?

Submit successfully!

Thank you for your feedback. Your feedback helps make our documentation better.

Failed to submit the feedback. Please try again later.

Which of the following issues have you encountered?







Please complete at least one feedback item.

Content most length 200 character

Content is empty.

OK Cancel