Help Center/ Data Replication Service/ Real-Time Disaster Recovery/ Task Management/ Task Life Cycle/ Stopping a DR Task
Updated on 2022-09-21 GMT+08:00
View PDF

Stopping a DR Task

When the DR task is complete or no longer needed, you can stop the DR task. You can stop a task in any of the following statuses:

  • Creating
  • Configuration
  • Initializing
  • Disaster recovery in progress
  • Paused
  • Disaster recovery failed
  • For a task in the Configuration state, it cannot be stopped if it fails to be configured.
  • After a task is stopped, it cannot be reset.

Procedure

  1. In the task list on the Disaster Recovery Management page, locate the target task and click Stop in the Operation column.
  2. In the displayed dialog box, click OK.

    • If the task status is abnormal (for example, the task fails or the network is abnormal), DRS will select Forcibly stop task to preferentially stop the task to reduce the waiting time.
    • Forcibly stopping a task will release DRS resources. Check whether the synchronization is affected.
    • To stop the task properly, restore the DRS task first. After the task status becomes normal, click Stop.

Stopping Tasks

  1. On the Disaster Recovery Management page, select tasks you wan to stop.
  2. Click Batch Operations in the upper left corner and choose Stop.

    Figure 1 Batch Operations

  3. In the displayed dialog box, confirm the task information and click Yes.
Parent topic: Task Life Cycle