ALM-15795217 hwPoePdClassInvalid
Description
PD with invalid IEEE class and power denied. (IfIndex=[IfIndex], Interface=[Interface])
The system detects that the PD class is invalid.
Attribute
AlarmID |
Alarm OID |
Alarm Severity |
Alarm Type |
---|---|---|---|
15795217 |
1.3.6.1.4.1.2011.5.25.195.40.10 |
Warning |
Equipment alarm |
Parameters
Name |
Meaning |
---|---|
IfIndex |
Interface index |
Interface |
Interface name |
Impact on the System
Services are not affected.
Possible Causes
Cause 1:
The PD may not comply with standards, whereas the switch supports 802.3af and 802.3at. In this case, the PD class cannot be identified by the switch.
Cause 2:
The PD hardware is faulty.
Cause 3:
The PoE chip of the device is faulty.
Procedure
- Run the poe legacy enable command on the interface to enable compatibility detection and then check whether the alarm is cleared.
If so, the alarm handling ends.
If not, go to step 2.
- Replace the PD with a standard PD and then check whether the alarm is cleared.
If so, the alarm handling ends.
If not, collect alarm information and configuration information, and then contact technical support personnel.
Related Information
None.
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
For any further questions, feel free to contact us through the chatbot.
Chatbot