Updated on 2024-01-25 GMT+08:00

ALM-15795206 hwConnectionThresholdExceed

Description

The number of connections has exceeded the threshold. (MaximumNumber = [MaximumNumber], CurrentConnecionNumber = [CurrentConnecionNumber], ThresholdPercent = [ThresholdPercent], ResumeThresholdPercent = [ResumeThresholdPercent])

The number of SD-WAN EVPN connections reaches 80% of the maximum number.

Attribute

Alarm ID

OID

Alarm Severity

Alarm Type

15795206

1.3.6.1.4.1.2011.5.25.241.6.3.5

Minor

Quality of service alarm

Parameters

Name Meaning

MaximumNumber

Maximum number of connections supported by the device.

CurrentConnecionNumber

Number of current connections of a device.

ThresholdPercent

Specifies the upper threshold percentage. The value is fixed at 80%.

ResumeThresholdPercent

Indicates the percentage of the link recovery threshold. The value is fixed at 50%.

Impact on the System

New connections may be not established.

Possible Causes

  • The size of sites is too large. The device needs to establish connections with all sites, which beyonds the threshold number of the device can support.

Procedure

  1. Adjust the topology between sites on the iMaster NCE-Campus page, connect the site to the Hub site, and relay packages through the Hub site. Check recover alarm can be generated.
    • If so, go to step 3.
    • If not, go to step 2.
  2. Collect alarm information and configuration information, and then contact technical support personnel.
  3. End.

Clearing

After the fault is rectified, the system clears this alarm, removing the need to manually clear it. This alarm will not be displayed on the Current Alarms page.