Help Center/ Edge Data Center Management/ User Guide/ Getting Started/ Logging In to or Logging Out of the NetEco/ Operating Environment Requirements
Updated on 2022-02-21 GMT+08:00
View PDF
Share

Operating Environment Requirements

Table 1 lists the requirements for the operating environment.

Table 1 Operating environment requirements

Configuration Item

Basic Configuration Requirement

CPU

I5-7500 or later

Memory

8 GB

Operating system

Windows 10 Professional 64-bit

Browser

You are advised to use the Chrome browser (stable channel edition) or Firefox browser (ESR edition) of the latest version.

  • If the user accesses the NetEco server through a proxy server, configure the proxy server as follows:
    For Chrome:
    1. Click in the upper right corner of the browser and choose Settings.
    2. On the Settings page, click Advanced, and then click Open proxy settings under System.
    3. In the Internet Properties dialog box, click LAN settings. In the Proxy server dialog box, select Use a proxy server for your LAN, set Address and Port, and click OK.
    4. Close the Settings tab page.
    For Firefox:
    1. Click in the upper right corner of the browser and choose Options.
    2. On the Options page, click Advanced, and then click Settings under Network.
    3. In the displayed Connection Settings dialog box, select Manual proxy configuration, set HTTP proxy and Port, and click OK.
    4. Close the Options tab page.
    NOTE:

    To ensure that the proxy server can access the NetEco server, the network bandwidth must meet the following requirements:

    Uplink (from the browser to the NetEco server) data rate: ≥ 100 kbit/s; downlink (from the NetEco server to the browser) data rate: ≥ 100 Mbit/s

  • To set exceptions for pop-up windows of the browser, perform the following steps:

    For Chrome:

    1. Click in the upper right corner of the browser and choose Settings.
    2. On the Settings page, click Privacy and security under Advanced, and click Pop-ups and redirects under Site settings in sequence.
    3. In the Pop-ups and redirects dialog box, click Add.
    4. In the Add a site dialog box, enter https://server IP address:server port number (https://10.10.10.1:31943 for example), and click Add.
    5. Close the Settings tab page.
    For Firefox:
    1. Click in the upper right corner of the browser and choose Options.
    2. On the Options page, click Content and Exceptions under Pop-ups in sequence.
    3. In the Allowed Sites dialog box, set Address of website to https://server IP address:server port number (https://10.10.10.1:31943 for example), click Allow, and then click Save Changes.
    4. Close the Options tab page.