Managing Tags of a VPC Endpoint Service

Scenarios

After a VPC endpoint service is created, you can view the added tags or add, edit or delete a tag.

A tag is a unique identifier of each VPC endpoint service, and it consists of a tag key and a tag value. You can add a maximum of 10 tags to each VPC endpoint service.

Add a Tag

Perform the following operations to add a tag for an existing VPC endpoint service:

1. Log in to the management console.
2. Click in the upper left corner and select the required region and project.

3. Choose Service List > Networking > VPC Endpoint.

4. In the navigation pane on the left, choose VPC Endpoint > VPC Endpoint Services.
5. In the VPC endpoint service list, locate the target VPC endpoint service and click its name.
6. On the displayed page, select the Tags tab.
7. Click Add Tag.
8. In the displayed dialog box, enter a key and a value.
   Table 1 describes the required parameters.

   Table 1 Tag requirements for VPC endpoint services

   Parameter	Requirement
   Tag key	Cannot be left blank. Must be unique for each resource. Can contain a maximum of 36 Unicode characters. Cannot start or end with a space or contain special characters =*<>\,|/
   Tag value	Cannot be left blank. Can contain a maximum of 43 Unicode characters. Cannot start or end with a space or contain special characters =*<>\,|/

9. Click OK.

Edit a Tag

Perform the following operations to edit a tag of an existing VPC endpoint service:

1. Log in to the management console.
2. Click in the upper left corner and select the required region and project.

3. Choose Service List > Networking > VPC Endpoint.

4. In the navigation pane on the left, choose VPC Endpoint > VPC Endpoint Services.
5. In the VPC endpoint service list, locate the target VPC endpoint service and click its name.
6. On the displayed page, select the Tags tab.
7. In the tag list, locate the target tag and click Edit in the Operation column.
8. Enter a new value.
   

   You can only edit values of exiting tags.

9. Click OK.

Delete a Tag

Perform the following operations to delete a tag of an existing VPC endpoint service:

Deleted tags cannot be recovered. Exercise caution when performing this operation.

1. Log in to the management console.
2. Click in the upper left corner and select the required region and project.

3. Choose Service List > Networking > VPC Endpoint.

4. In the navigation pane on the left, choose VPC Endpoint > VPC Endpoint Services.
5. In the VPC endpoint service list, locate the target VPC endpoint service and click its name.
6. On the displayed page, select the Tags tab.
7. In the tag list, locate the target tag and click Delete in the Operation column.
8. Click Yes.