Huawei USG6600 Series

Updated on 2024-10-11 GMT+08:00

View PDF

This section uses a Huawei USG6600 series firewall running V100R001C30SPC300 as an example to describe how to configure VPN.

Assume that the subnets of the data center are 192.168.3.0/24 and 192.168.4.0/24, the subnets of the VPC are 192.168.1.0/24 and 192.168.2.0/24, and the public IP address of the IPsec tunnel egress in the VPC is 1.1.1.1, which can be obtained from the local gateway parameters of the IPsec VPN in the VPC.

Procedure

Check firewall version information.

display version 
17:20:502017/03/09
Huawei Versatile Security Platform Software
Software Version: USG6600 V100R001C30SPC300(VRP (R) Software, Version 5.30)

Create an access control list (ACL) and bind it to the target VPN instance.

acl number 3065 vpn-instance vpn64
rule 1 permit ip source 192.168.3.0 0.0.0.255 destination 192.168.1.0 0.0.0.255
rule 2 permit ip source 192.168.3.0 0.0.0.255 destination 192.168.2.0 0.0.0.255
rule 3 permit ip source 192.168.4.0 0.0.0.255 destination 192.168.1.0 0.0.0.255
rule 4 permit ip source 192.168.4.0 0.0.0.255 destination 192.168.2.0 0.0.0.255
q

Create an IKE proposal.

ike proposal 64 
dh group5 
authentication-algorithm sha1 
integrity-algorithm hmac-sha2-256 
sa duration 3600 
q

Create an IKE peer and bind it to the created IKE proposal. The peer IP address is 1.1.1.1.

ike peer vpnikepeer_64
pre-shared-key ******** (******** specifies the pre-shared key.)
ike-proposal 64
undo version 2
remote-address vpn-instance vpn64 1.1.1.1
sa binding vpn-instance vpn64
q

Create an IPsec proposal.

IPsec proposal IPsecpro64
encapsulation-mode tunnel
esp authentication-algorithm sha1
q

Create an IPsec policy, and bind the IKE policy and IPsec proposal to it.

IPsec policy vpnIPsec64 1 isakmp
security acl 3065
pfs dh-group5
ike-peer vpnikepeer_64
proposal IPsecpro64
local-address xx.xx.xx.xx
q

Apply the IPsec policy to the corresponding sub-interface.

interface GigabitEthernet0/0/2.64
IPsec policy vpnIPsec64
q

Test the connectivity.
After you perform the preceding operations, you can test the connectivity between your ECSs in the cloud and the hosts in your data center. For details, see the following figure.