Adding a DNAT Rule

Scenarios

After a private NAT gateway is created, you can add DNAT rules to allow servers in your VPC to provide services accessible from on-premises servers or other VPCs.

A DNAT rule needs to be configured for each port on a server that needs to be made accessible. If multiple ports on a server or multiple servers need to provide services accessible from on-premises servers or other VPCs, multiple DNAT rules need to be configured.

Notes and Constraints

A DNAT rule with Port Type set to All ports cannot share a transit IP address with a DNAT rule with Port Type set to Specific port.

Prerequisites

• A private NAT gateway is available.
• A transit IP address is available.

Procedure

1. Go to the private NAT gateway list page.

2. On the Private NAT Gateways page, click the name of the private NAT gateway on which you need to add a DNAT rule.
3. On the private NAT gateway details page, click the DNAT Rules tab.
4. Click Add DNAT Rule.
   

   After you add a DNAT rule, add rules to the security group associated with the servers to allow inbound or outbound traffic. Otherwise, the DNAT rule does not take effect.

5. Configure required parameters. For details, see Table 1.

   Table 1 Descriptions of DNAT rule parameters

   Parameter	Description
   Local Network
   Port Type	The port type The type can be: Specific port: The private NAT gateway only forwards requests to your servers from the outside port and to the inside port configured here, and only if they use the right protocol. All ports: All requests received by the gateway through all ports over any protocol will be forwarded to the private IP address of your server.
   Protocol	The protocol can be TCP or UDP If you select All ports, the value of this parameter is All by default. This parameter is only available if you select Specific port for Port Type.
   Instance Type	The type of instance that will provide services accessible from on-premises data centers or other VPCs Possible types are: Server Virtual IP address Load balancer Custom
   NIC	The NIC of the server This parameter is only available if you set Instance Type to Server.
   IP Address	The IP address of the server that will provide services accessible from on-premises data centers or other VPCs. This parameter is only available if you set Instance Type to Custom.
   Internal Port	The port of the instance Range: 1 to 65535 This parameter is only available if you select Specific port for Port Type.
   Transit Network
   Transit IP Address	The transit IP address used to access on-premises data centers or other VPCs You can select a transit IP address that is not bound to any resource, has been bound to a DNAT rule for the current private NAT gateway where Port Type is set to Specific port, or has been bound to an SNAT rule of the current private NAT gateway.
   Transit IP Address Port	The port of the transit IP address Supported range: 1 to 65535 This parameter is only available if you select Specific port for Port Type.
   Description	Provides supplementary information about the DNAT rule. Enter up to 255 characters. Angle brackets (<>) are not allowed.

6. Click OK.

   Once the rule is created, its status changes to Running.

Helpful Links

Managing DNAT Rules