Hardware Description

This section uses the USG6585E as an example. Other models are slightly different from the USG6585E. For details, see "Installation > Hardware Guide > Hardware Overview" in the HUAWEI USG6000E Product Documentation.

Figure 1 Appearance and auxiliary materials of the USG6585E

Click to enlarge

**Table 1** USG6585E service port description
Port Name	Description
Combo ports (0–7)	The electrical port and its corresponding optical port are multiplexed. They cannot both work. (For example, when an optical port is activated, the corresponding electrical port is automatically disabled.) Electrical and optical ports share the same interface view and are numbered from GigabitEthernet0/0/0 to GigabitEthernet0/0/7. By default, a combo port works as the electrical port. You can run the combo enable { copper \| fiber } command to configure a combo port to work as an electrical port or optical port as required.
WAN ports (0 and 1)	The ports are numbered as WAN0/0/0 and WAN0/0/1.
10GE optical ports (0 and 1)	The ports are numbered as XGigabitEthernet0/0/0 and XGigabitEthernet0/0/1.
MGMT port	Management interface of the device. The port is MEth0/0/0 and its default IP address is 192.168.0.1.

**Table 2** USG6585E indicator description
Silkscreen	Name	Color	Status	Description
PWR	Power indicator	Green	Steady on	The power module is working properly.
PWR	Power indicator	-	Steady off	The power module is faulty or the device is not powered on.
SYS	SYS indicator	Green	Steady on	The system is being powered on or restarted.
		Green	Blinks once every 2 seconds (0.5 Hz)	The system is running properly.
		Green	Blinks four times every second (4 Hz)	The system is starting.
		Red	Steady on	A system fault occurs.
		-	Steady off	The system is not running.