Security Group Rules

Constraints and Limitations

• If health check is enabled for a backend server group, security group rules must allow traffic from the health check port over the health check protocol.
• If UDP is used for health check, there must be a rule that allows ICMP traffic. If there is no such rule, the health of the backend servers cannot be checked.

Configuring Security Group Rules

If you have no VPCs when creating a server, the system automatically creates one for you. Default security group rules allow only communications among the servers in the VPC. To ensure that the load balancer can communicate with these servers over both the frontend port and health check port, configure inbound rules for security groups containing these servers.

1. Log in to the management console.
2. In the upper left corner of the page, click and select the desired region and project.
3. Under Computing, click Elastic Cloud Server.
4. On the Elastic Cloud Server page, click the name of the ECS that has been added to a backend server group.

   The page providing details about the ECS is displayed.

5. Click Security Groups, locate the security group, and view security group rules.
6. Click the ID of a security group rule or Modify Security Group Rule. The security group details page is displayed.
7. On the Inbound Rules tab page, click Add Rule. Configure an inbound rule based on Table 1.

   Table 1 Security group rules

   Backend Protocol	Policy	Protocol & Port	Source IP Address
   HTTP	Allow	Protocol: TCP Port: the port used by the backend server and health check port	100.125.0.0/16 and 100.126.0.0/16
   TCP	Allow	Protocol: TCP Port: health check port	100.125.0.0/16 and 100.126.0.0/16
   UDP	Allow	Protocol: UDP and ICMP Port: health check port	100.125.0.0/16 and 100.126.0.0/16

8. Click OK.

Configuring Network ACL Rules

To control traffic in and out of a subnet, you can associate a network ACL with the subnet. Network ACL rules control access to subnets and add an additional layer of defense to your subnets. Default network ACL rules reject all inbound and outbound traffic. If the subnet of a load balancer or associated backend servers has a network ACL associated, the load balancer cannot receive traffic from the Internet or route traffic to backend servers, and backend servers cannot receive traffic from and respond to the load balancer.

Configure an inbound network ACL rule to permit access from 100.125.0.0/16 and 100.126.0.0/16.

ELB translates the public IP addresses used to access backend servers into private IP addresses in 100.125.0.0/16 and 100.126.0.0/16. You cannot configure rules to prevent public IP addresses from accessing backend servers.

1. Log in to the management console.
2. In the upper left corner of the page, click and select the desired region and project.
3. Hover on in the upper left corner to display Service List and choose Network > Virtual Private Cloud.
4. In the navigation pane on the left, choose Access Control > Network ACLs.
5. In the network ACL list, click the name of the network ACL to switch to the page showing its details.
6. On the Inbound Rules or Outbound Rules tab page, click Add Rule to add an inbound or outbound rule.
   • Action: Select Allow.
   • Protocol: The protocol must be the same as the backend protocol.
   • Source: Set it to 100.125.0.0/16 and 100.126.0.0/16.
   • Source Port Range: Select a port range.
   • Destination: Enter a destination address allowed in this direction. The default value is 0.0.0.0/0, which indicates that traffic from all IP addresses is permitted.
   • Destination Port Range: Select a port range.
   • (Optional) Description: Describe the network ACL rule.
7. Click OK.