Radio Parameter Reporting Test

Overview

This test case checks the radio signal data (signal strength, coverage level, signal to noise ratio, and cell ID) reported by the device.

To execute this test case, you need to define the following radio signal parameters in the profile file and set up the mapping in codec.

Procedure

1. On the Radio Singnal Parameter Reporting page, click Next to start the test.
2. Enter the test page according to the wizard. Use the physical device to report the radio signal parameters defined in the profile file, and view the test result.
   • If the test is successful, click Next to proceed to the next phase.
   • If the test fails, rectify the fault and click Retest.
   NOTE:

   The reported radio signal parameter values must be within the ranges.