Viewing and Changing a Floating IP Address

Scenarios

You can change floating IP addresses after migrating on-premises databases or other cloud databases to RDS.

Constraints

After a floating IP address is changed, the domain name needs to be resolved again. This operation takes several minutes and may interrupt database connections. Therefore, you are advised to change a floating IP address during off-peak hours.

Only floating IPv4 addresses can be changed.

Procedure

You can use a self-configured floating IP address when creating a DB instance.

You can change the floating IP address of an existing DB instance.

Log in to the management console.
Click in the upper left corner and select a region.
Click in the upper left corner of the page and choose Databases > Relational Database Service.
On the Instances page, click the instance name to go to the Overview page.
Under Floating IP Address, click Configure.

Alternatively, in the navigation pane on the left, choose Connectivity & Security. In the Connection Information area, click Change next to the Floating IP Address field.
In the displayed dialog box, check the number of in-use IP addresses. If the in-use IP addresses are less than 254, there are unused floating IP addresses.

Figure 1 Changing a floating IP address
Enter an available IP address and click OK.

An in-use IP address cannot be used as the new floating IP address of the DB instance.
If you have enabled operation protection, click Send Code in the displayed Identity Verification dialog box and enter the obtained verification code. Then, click OK.

Two-factor authentication improves the security of your account and cloud product. For details about how to enable operation protection, see the Identity and Access Management User Guide.