Overview

Dedicated load balancers support hybrid load balancing. You can add servers and supplementary network interfaces in the VPC where the load balancer is created, in a different VPC, or in an on-premises data center, by using private IP addresses of the servers to the backend server group of the load balancer.

In this way, incoming traffic can be flexibly distributed to cloud servers and on-premises servers.

Figure 1 Routing requests to cloud and on-premises servers

Constraints and Limitations

IP as a backend cannot be disabled after it is enabled.
Only private IPv4 addresses can be added as backend servers.
A maximum of 50,000 concurrent connections can be established with a backend server that is added by using its IP address.
If you add IP addresses as backend servers, the source IP addresses of the clients cannot be passed to these servers.

Scenario

After you enable IP as a backend, you can add backend servers by using their IP addresses. You need to get prepared for different scenarios as shown in Table 1.

**Table 1** Adding IP addresses as backend servers
Where Servers Are Running	Preparations
In a different VPC from the load balancer	Set up a VPC peering connection between the VPC where the load balancer is running and the VPC where the servers are running. For details about how to set up a VPC peering connection, see the .
In on-premises data centers	Connect the on-premises data center to the VPC where the load balancer is running through Direct Connect or VPN. For details about how to connect on-premises data centers to the cloud, see the or .