Help Center/ Meeting/ FAQs/ Hard Terminal Service Usage Problems/ How Do I Activate the TE30/TE40/TE50/TE60 Through Wi-Fi?
Updated on 2022-11-28 GMT+08:00
View PDF
Share

How Do I Activate the TE30/TE40/TE50/TE60 Through Wi-Fi?

Use the remote control to connect the hard terminal to a Wi-Fi network and activate the hard terminal.

1. Set the connection type.

It is recommended that you set Connection type to Dynamic IP when the hard terminal is connected to a Wi-Fi network.

If the hard terminal is powered on for the first time, set the IPv4 connection type to Dynamic IP in Wizard > General.

If the hard terminal has not used before, choose Advanced > Settings > Network > IP and set the IP address to Dynamic IP.

2. Connect to the Wi-Fi network.

If you are on the setup wizard screen, press the Back key to exit the wizard.

Choose Advanced > Settings > Network > Wi-Fi, enable Wi-Fi, and select the Wi-Fi network to be connected. When the connection status indicator is on, the connection is successful.

3. Activate the hard terminal.

Choose Advanced > Settings > Installation > Wizard, and activate the hard terminal.