Connecting to an ActiveMQ Data Source

Overview

ROMA Connect can use ActiveMQ as a data source for data integration tasks. Before using the ActiveMQ data source, you need to connect it to ROMA Connect.

Prerequisites

Each connected data source must belong to an integration application. Before connecting a data source, ensure that an integration application is available. Otherwise, create an integration application in advance.

Procedure

1. Log in to the ROMA Connect console. On the Instances page, click View Console next to a specific instance.
2. In the navigation pane on the left, choose Data Sources. In the upper right corner of the page, click Access Data Source.
3. On the Default tab page, select ActiveMQ and click Next.
4. Configure the data source connection information.

   Table 1 Data source connection information

   Parameter	Description
   Name	Enter a data source name. It is recommended that you enter a name based on naming rules to facilitate search.
   Integration Application	Select the integration application to which the data source belongs.
   Description	Enter the descriptive information.
   Broker List	Enter the broker connection address of ActiveMQ, that is, the IP address and port number of the host. Click Add Address to add addresses.
   Username	Enter the username for connecting to ActiveMQ.
   Password	Enter the password for connecting to ActiveMQ.
   SSL Authentication	Determine whether to use SSL authentication for the connection between ROMA Connect and ActiveMQ.
   Authentication Mode	This parameter is mandatory only if SSL Authentication is set to Enable. Select the SSL authentication mode. One-way SSL: Only the client (ROMA Connect) authenticates the server (ActiveMQ). Two-way SSL: The client (ROMA Connect) and server (ActiveMQ) authenticate each other.
   Trust Store	This parameter is mandatory only if SSL Authentication is set to Enable. This parameter specifies the trust store used by the client during SSL authentication. It must match the private key used by the server.
   Trust Store Password	This parameter is mandatory only if SSL Authentication is set to Enable. Enter the password of the trust store.
   Keystore	This parameter is mandatory only if SSL Authentication Mode is set to Two-way SSL. This parameter specifies the keystore used by the client during SSL two-way authentication. It must match the public key used by the server.
   Keystore Password	This parameter is mandatory only if SSL Authentication Mode is set to Two-way SSL. Enter the password of the keystore.
   Keystore Key Password	This parameter is mandatory only if SSL Authentication Mode is set to Two-way SSL. Enter the password of the keystore key. If this parameter is not specified, the keystore key password is the same as the keystore password.

   The following is an example of connecting to an ActiveMQ in one-way SSL authentication mode. You need to upload the trust store.

   Figure 1 ActiveMQ data source configuration example
   
5. Click Check Connectivity to check the connectivity between ROMA Connect and the data source.
   • If the test result is Data source connected successfully, go to the next step.
   • If the test result is Failed to connect to the data source, check the data source status and connection parameters, and click Recheck until the connection is successful.
6. Click Create.