Help Center/
Application Operations Management/
FAQs (2.0)/
O&M Management (Retiring)/
What Can I Do If "agent not found" Is Displayed?
Updated on 2024-04-11 GMT+08:00
What Can I Do If "agent not found" Is Displayed?
Symptom
Message "agent not found" is displayed when I execute a script on an ECS.
Possible Causes
- The UniAgent is not properly installed.
- The UniAgent is not in the Running state.
Solution
Check the UniAgent status and perform operations by following the instructions below:
- Error: The UniAgent is not working. Contact technical support.
- Installing: The UniAgent is being installed. The installation takes about 1 minute to complete.
- Installation failed: The UniAgent fails to be installed. Install it again.
- Not installed: The UniAgent has not been installed. Install it by referring to Installing a UniAgent.
After the UniAgent status changes to Running, execute the script on the ECS again.
Parent topic: O&M Management (Retiring)
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
The system is busy. Please try again later.
For any further questions, feel free to contact us through the chatbot.
Chatbot