Help Center/ Virtual Private Cloud/ User Guide (Paris Regions) / FAQ/ Connectivity/ Why Does My ECS Fail to Obtain an IP Address?
Updated on 2024-03-05 GMT+08:00

Why Does My ECS Fail to Obtain an IP Address?

Symptom

The private IP address of the ECS fails to be obtained.

Troubleshooting

Locate the fault based on the following procedure.

Figure 1 Troubleshooting process
  1. Checking Whether DHCP Is Enabled
  2. Checking Whether the dhclient Process Exist
  3. Checking ECS Logs

Checking Whether DHCP Is Enabled

Check whether the DHCP function of the subnet is enabled (enabled by default).

Switch to the subnet details page. If DHCP is disabled, you must manually configure a static IP address for the ECS by referring to step 3.

Checking Whether the dhclient Process Exist

  1. Check whether the dhclient process exists:

    ps -ef | grep dhclient

  2. If the dhclient process does not exist, log in to the ECS and restart the ECS NIC or send a DHCP request.
    • Linux:

      Run the dhclient ethx command. If dhclient commands are supported, run the ifdown ethx;ifup ethx command. In the command, ethx indicates the ECS NIC, for example, eth0 and eth1.

    • Windows:

      Disconnect the network connection and connect it.

  3. If the DHCP client does not send requests for a long time, for example, the fault occurs again after the NIC restarts, you can use the following method to configure the static IP address.
    • Linux:
      1. Run the following command to open the /etc/sysconfig/network-scripts/ifcfg-eth0 file:

        vi /etc/sysconfig/network-scripts/ifcfg-eth0

      2. Modify the following configuration items in the /etc/sysconfig/network-scripts/ifcfg-eth0 file.

        BOOTPROTO=static

        IPADDR=192.168.1.100 #IP address

        NETMASK=255.255.255.0 #Subnet mask

        GATEWAY=192.168.1.1 #Gateway address

      3. Run the following command to restart the network service:

        service network restart

    • Windows:

      On the Local Area Connection Status tab, click Properties. In the displayed area, select Internet Protocol Version 4 (TCP/IPv4) and click Properties. In the displayed area, enter the IP address, subnet mask, and the default gateway address.

Checking ECS Logs

Check the ECS messages log in the /var/log/messages directory.

Search for the NIC MAC address and check whether there are any processes causing failures in obtaining IP addresses over DHCP.