Adding a TCP Listener

Scenarios

You can add a TCP listener, if high reliability and high accuracy are required but slow speed is acceptable. TCP works well for applications such as file transfer, email sending and receiving, and remote login.

Constraints

• If the front protocol is TCP, the backend protocol defaults to TCP and cannot be changed.
• If you only select application load balancing (HTTP/HTTPS) for your dedicated load balancer, you cannot add a TCP listener to this load balancer.

Procedure

1. Log in to the management console.
2. In the upper left corner of the page, click and select the desired region and project.
3. Click in the upper left corner to display Service List and choose Networking > Elastic Load Balance.
4. On the Load Balancers page, locate the load balancer and click its name.
5. Under Listeners, click Add Listener. Configure the parameters based on Table 1.

   Table 1 Parameters for configuring a TCP listener

   Parameter	Description
   Name	Specifies the listener name.
   Frontend Protocol	Specifies the protocol that will be used by the load balancer to receive requests from clients. Select TCP.
   Listen to All Ports	This option is available only for TCP or UDP listeners of a dedicated load balancer. It cannot be disabled after it is enabled. If this option is enabled, the listener listens to requests from all ports in the port range you specify and routes the requests to the corresponding ports on the backend servers.
   Frontend Port	Specifies the port that will be used by the load balancer to receive requests from clients. The port number ranges from 1 to 65535. NOTE: If you enable Listen to All Ports, you need to enter a start and end port number as the port range.
   Access Control	Specifies how access to the listener is controlled. For details, see What Is Access Control? The following options are available: All IP addresses Blacklist Whitelist
   IP Address Group	Specifies the IP address group associated with a whitelist or blacklist. If there is no IP address group, create one first. For more information, see IP Address Group.
   Transfer Client IP Address	Specifies whether to transmit IP addresses of the clients to backend servers. This function is enabled for dedicated load balancers by default and cannot be disabled.
   Advanced Settings
   Idle Timeout	Specifies the length of time for a connection to keep alive, in seconds. If no request is received within this period, the load balancer closes the connection and establishes a new one with the client when the next request arrives. The idle timeout duration ranges from 10 to 4000.
   Description	Provides supplementary information about the listener. You can enter a maximum of 255 characters.

6. Click Next: Configure Request Routing Policy.
   1. You are advised to select an existing backend server group.
   2. You can also click Create new to create a backend server group.
      1. Configure the backend server group based on Table 3.
      2. Click Next: Add Backend Server. Add backend servers and configure health check for the backend server group.

         For details about how to add backend servers, see Backend Server Overview. For the parameters required for configuring a health check, see Table 4.

7. Click Next: Confirm.
8. Confirm the configurations and click Submit.