Changing a Backend Server Group

Scenario

This section describes how you can change the default backend server group configured for a listener.

TCP or UDP listeners forward requests to the default backend server groups.

HTTP or HTTPS listeners forward requests based on the priorities of the forwarding policies. If you do not add a forwarding policy, the listener will route the requests to the default backend server group.

Constraints and Limitations

• The backend server group cannot be changed if redirection is enabled.
• The backend protocol of the backend server group must match the frontend protocol of the listener. For details, see Table 3.

Procedure

1. Log in to the management console.
2. In the upper left corner of the page, click and select the desired region and project.
3. Hover on in the upper left corner to display Service List and choose Networking > Elastic Load Balance.
4. On the Load Balancers page, locate the target load balancer and click its name.
5. On the Listeners tab, locate the target listener and click its name.
6. On the Summary page, click Change Backend Server Group on the right.
7. In the displayed dialog box, click the server group name box.
   Select a backend server group from the drop-down list or create a group.

   1. Click the name of the backend server group or enter the name in the search box to search for the target group.
   2. Click Create Backend Server Group. After the backend server group is created, click the refresh icon.
      

      The backend protocol of the new backend server group must match the frontend protocol of the listener.

8. Click OK.