Help Center> Data Lake Factory> User Guide> References> Nodes> Open/Close Resource

Updated on 2022-02-22 GMT+08:00

View PDF

Open/Close Resource

The Open/Close Resource node is used to enable or disable the HUAWEI CLOUD service.

Table 1 and Table 2 describe the parameters of the Open/Close Resource node.

**Table 1** Parameters of Open/Close Resource nodes
Parameter	Mandatory	Description
Node Name	Yes	Name of the node. Must consist of 1 to 128 characters and contain only letters, digits, underscores (_), hyphens (-), slashes (/), less-than signs (<), and greater-than signs (>).
Service	Yes	Service to be opened or closed. ECS CDM CS
Open/Close Resource	Yes	Possible values: On Off
Instance	Yes	Object to be opened or closed, for example, to open a CDM cluster.

**Table 2** Advanced parameters
Parameter	Mandatory	Description
Node Status Polling Interval (s)	Yes	Specifies how often the system check completeness of the node task. The value ranges from 1 to 60 seconds.
Max. Node Execution Duration	Yes	Execution timeout interval for the node. If retry is configured and the execution is not complete within the timeout interval, the node will not be retried and is set to the failed state.
Retry upon Failure	Yes	Indicates whether to re-execute a node task if its execution fails. Possible values: Yes: The node task will be re-executed, and the following parameters must be configured: Maximum Retries Retry Interval (seconds) No: The node task will not be re-executed. This is the default setting. NOTE: If Timeout Interval is configured for the node, the node will not be executed again after the execution times out. Instead, the node is set to the failure state.
Failure Policy	Yes	Operation that will be performed if the node task fails to be executed. Possible values: End the current job execution plan Go to the next job Suspend the current job execution plan Suspend execution plans of the current and subsequent nodes