Step 4: Modify VPC Route Tables
This section describes how to modify the route table of a protected VPC to direct the route to an enterprise router.
You need to modify the route tables of at least two VPCs. Each time a protected VPC is added, you need to add a route for that VPC.
Procedure
- In the service list, click Virtual Private Cloud under Networking. In the navigation pane, choose Route Tables.
- In the Name/ID column, click the route table name of a VPC. The Summary page is displayed.
- Click Add Route. For more information, see Table 1.
Table 1 Route parameters Parameter
Description
Destination Type
Select IP address.
Destination
Destination CIDR block.
NOTE:The value cannot conflict with existing routes or subnet CIDR blocks in the VPC.
Next Hop Type
Select Enterprise Router from the drop-down list.
Next Hop
Select a resource for the next hop.
The enterprise routers you created are displayed in the drop-down list.
Description
(Optional) Description of a route.
NOTE:Enter up to 255 characters. Angle brackets (< or >) are not allowed.
You need to add routes for at least two VPCs. Each time a protected VPC is added, you need to add a route for that VPC.
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
For any further questions, feel free to contact us through the chatbot.
Chatbot