Help Center > > FAQs> Read Replicas and Read/Write Splitting> How Do I Configure a Read/Write Splitting Address?

How Do I Configure a Read/Write Splitting Address?

Updated at: Jun 09, 2021 GMT+08:00

After a read replica is created, you can enable Read/Write Splitting and connect to the DB instance through a read/write splitting address.

  • After read/write splitting is enabled, an additional address called a read/write splitting address is automatically provided. To use read/write splitting, switch your applications to this address.
  • After read/write splitting is enabled, databases can be connected through a read/write splitting address.

    The read/write splitting address and the floating IP address of the primary DB instance are in the same VPC and subnet and are independent from each other.

Did you find this page helpful?

Submit successfully!

Thank you for your feedback. Your feedback helps make our documentation better.

Failed to submit the feedback. Please try again later.

Which of the following issues have you encountered?







Please complete at least one feedback item.

Content most length 200 character

Content is empty.

OK Cancel