Creating a Server Template

Scenarios

SMS allows you to create server templates for quick configuration. You can use these templates to quickly configure target server settings, such as VPC, Subnet, and Security Group.

Procedure

1. Log in to the management console.
2. Click Service List. Under Migration, click Server Migration Service.
3. In the navigation pane on the left, choose Configurations to switch to the desired page.
4. In the upper right corner of the Server Templates area, click Create Server Template.
5. Enter a template name, click next to Configuration, and set parameters listed in Table 1.

   Table 1 Parameters

   Parameter	Description
   Region	Select a region where the target server resides from the drop-down list. By default, the region is the one set in the default migration template, but you can select another region you want to use.
   Project	Select a project in the region from the drop-down list. You can select a project only after a region is selected.
   VPC	If you select Create during migration, SMS will recommend a VPC when you use this template to configure the target server. If the source IP address is 192.168.X.X, SMS will recommend a VPC and a subnet that both belong to network segment 192.168.0.0/16. If the source IP address is 172.16.X.X, SMS will recommend a VPC and a subnet that both belong to network segment 172.16.0.0/12. If the source IP address is 10.X.X, SMS will recommend a VPC and a subnet that both belong to network segment 10.0.0.0/8.
   Subnet	If you select Create during migration, SMS will recommend a subnet when you use this template to configure the target server. The subnet is in the same network segment as the VPC.
   Security Group	If you select Create during migration, SMS will recommend a security group and allow traffic on required ports when you use this template to configure the target server. Windows: ports 8899, 8900, and 22 Linux: port 22 for file-level migration and ports 8900 and 22 for block-level migration
   AZ	The parameter is set to Random by default. You can also select another AZ.
   Data Disk	The value can be Common I/O, High I/O, or Ultra-high I/O.

6. Click OK.

Related Operations

You can perform the following operations on a created server template.