ALM-303046961 Interface input flow bandwidth usage exceeded the trap threshold
Description
IFNET/4/INBWRATEEXCEED: OID [OID] Interface input flow bandwidth usage exceeded the trap threshold. (Interface=[INTEGER], BandWidthUsage=[INTEGER], TrapThreshold=[INTEGER], InterfaceName=[STRING])
The trap was generated when the percentage of the rate of received traffic to the total bandwidth on an interface was greater than the threshold.
Attribute
Alarm ID |
Alarm Severity |
Alarm Type |
---|---|---|
303046961 |
Warning |
environmentalAlarm |
Parameters
Name |
Meaning |
---|---|
OID |
Indicates the MIB object ID of the alarm. |
Interface |
Indicates the interface index. |
BandWidthUsage |
Indicates bandwidth usage. |
TrapThreshold |
Indicates the trap threshold of bandwidth usage. |
InterfaceName |
Indicates the interface name. |
Impact on the System
When the rate of traffic is close to 100% out of the total bandwidth, delay or packet loss will occur.
Possible Causes
The rate of traffic received by the interface was too large.
Procedure
- Run the display this interface command on the interface to check whether the traffic threshold is too low. The threshold range is specified by users according to actual services.
- If so, go to Step 2.
- If not, go to Step 3.
- Run the trap-threshold input-rate threshold_value command to reset the threshold and then check whether the alarm is cleared.
- If so, go to Step 4.
- If not, go to Step 3.
- Collect alarm information and configuration information, and then contact technical support personnel.
- End.
Related Information
ALM-303046962 Interface output flow bandwidth usage exceeded the trap threshold
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
For any further questions, feel free to contact us through the chatbot.
Chatbot