ALM-135463087 hwIfMonitorOutputRateRising
Description
Interface output flow bandwidth usage exceeded the trap threshold. (Interface=[IfIndex], BandWidthUsage=[hwIfMonitorOutputRatePercentage], TrapThreshold=[hwIfMonitorOutputRateThreshold], InterfaceName=[InterfaceName])
This object indicates that an alarm is generated when the ratio of the traffic sent by an interface to the total bandwidth of the interface exceeds the threshold.
Attribute
AlarmID |
Alarm OID |
Alarm Severity |
Alarm Type |
---|---|---|---|
135463087 |
1.3.6.1.4.1.2011.5.25.41.4.7 |
Warning |
Processing error alarm |
Parameters
Parameter |
Description |
---|---|
IfIndex |
Interface index |
hwIfMonitorOutputRatePercentage |
Output traffic statistics. |
hwIfMonitorOutputRateThreshold |
Output traffic alarm threshold. |
InterfaceName |
Interface name. |
Impact on the System
When the traffic is close to 100% of the bandwidth, delay or packet loss may occur.
Possible Causes
The rate of traffic sent by the interface was too large.
Procedure
1. Run the display this interface command in the interface view to check whether the traffic threshold is too low.Determine the alarm threshold based on service requirements.
- If yes, go to step 2.
- If not, go to Step 3.
2. Run the trap-threshold output-rate bandwidth-in-use command in the interface view to reconfigure the alarm threshold. Then check whether the alarm is cleared.
- If yes, go to Step 4.
- If not, go to Step 3.
3. Collect alarm and configuration information, and contact technical support personnel.
4. End.
Related Information
None.
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
For any further questions, feel free to contact us through the chatbot.
Chatbot