Step 5: Add a Route
Scenarios
After the private NAT gateway is configured, add a route in the route table of the service VPC to point to the private NAT gateway.
Procedure
- Log in to the management console.
- Click in the upper left corner and select the desired region and project.
- Click Service List in the upper left corner. Under Network, select Virtual Private Cloud.
- In the navigation pane on the left, choose Route Tables.
- In the route table list, click the name of the route table associated the service VPC.
- Click Add Route and configure required parameters.
Table 1 Parameter descriptions Parameter
Description
Destination
The destination CIDR block
Set it to the CIDR block used by your on-premises data center.
Next Hop Type
Set it to NAT gateway.
Next Hop
Set Next Hop to the private NAT gateway.
Description
(Optional) Supplementary information about the route
Enter up to 255 characters. Angle brackets (< or >) are not allowed.
- Click OK.
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
For any further questions, feel free to contact us through the chatbot.
Chatbot