Help Center> Edge Data Center Management> User Guide> Getting Started> Setting NetEco Communications Parameters on the ECC800-Pro
Updated on 2022-02-21 GMT+08:00
View PDF

Setting NetEco Communications Parameters on the ECC800-Pro

The ECC800-Pro can connect to the NetEco only after communications parameters are set on the ECC800-Pro WebUI.

Prerequisites

  • You have obtained the IP address of the ECC800-Pro as well as the user name and password used for WebUI login.
  • You have obtained the IP address of the NetEco server.

Procedure

  1. Enter https://monitoring IP address (such as https://192.168.1.10) in the address box of the browser, and then press Enter to enter the Web login page.

  2. On the login page, enter the user name and password, select a language, and click Log In.

    • If you do not perform any operation within 10 minutes after logging in to the system, you will be logged out due to timeout.
    • A maximum of three users can log in to the ECC800-Pro WebUI at the same time.

  3. Choose System Settings > NMS Application.
  4. Click the NetEco tab. In the Communication Parameters area, set parameters such as Server IP, Port number, and Network port for link setup, and click Submit.

    The parameters to be set for the ECC800-Pro vary according to the software version. Set the parameters based on the actual version.

    Table 1 NetEco parameters

    Parameter Name

    Value

    Server IP

    Set this parameter to the IP address of the NetEco server.

    NOTE:

    The NetEco IP address and the ECC800-Pro IP address must be configured in the same network to ensure normal connection between the NetEco and the ECC800-Pro.

    Port number

    31220

    Network port for link setup

    WAN_1

Parent topic: Getting Started