Flink Client CLI

Common CLIs

Common Flink CLIs are as follows:

1. yarn-session.sh
   • You can run yarn-session.sh to start a standing Flink cluster to receive tasks submitted by clients. Run the following command to start a Flink cluster with three TaskManager instances:

     bin/yarn-session.sh

   • Run the following command to obtain other parameters of yarn-session.sh:

     bin/yarn-session.sh -help

2. flink
   • You can run Flink commands to submit a Flink job to a standing Flink cluster or to execute the job in single-server mode.
     • Run the following command to submit a Flink job to a standing Flink cluster:

       bin/flink run ../examples/streaming/WindowJoin.jar

       

       Before using the command to submit a task, you need to run yarn-session.sh to start the Flink cluster.

     • Run the following command to execute a per-job YARN Cluster mode:

       bin/flink run -m yarn-cluster ../examples/streaming/WindowJoin.jar

       

       The -m yarn-cluster parameter is used to specify a job to independently start a Flink cluster.

     • List scheduled and running jobs (including their JobIDs):

       bin/flink list

     • Cancel a job:

       bin/flink cancel <jobID>

     • Stop a job (streaming jobs only):

       bin/flink stop <jobID>

       

       The difference between cancelling and stopping a (streaming) job is the following:

       • Cancel a job: On a cancel call, the operators in a job immediately receive a cancel() method call to cancel them as soon as possible. If operators are not stopping after the cancel call, Flink will start interrupting the thread periodically until it stops.
       • Stop a job: Stop is only available for jobs which use sources that implement the StoppableFunction interface. The job will keep running until all sources properly shut down. Stop a job is more graceful than cancel, but it may cause the job to stop failing.
   • Run the following command to obtain other parameters of Flink commands:

     bin/flink --help

Precautions

• If yarn-session.sh uses -z to configure the specified ZooKeeper NameSpace, you need to use -yid to specify the application ID and use -yz to specify the ZooKeeper NameSpace when using flink run. The NameSpaces must the same.

  Example:

  bin/yarn-session.sh -z YARN101
  bin/flink run -yid application_****_**** -yz YARN101 examples/streaming/WindowJoin.jar

• If yarn-session.sh does not use -z to configure the specified ZooKeeper NameSpace, do not use -yz to specify the ZooKeeper NameSpace when using flink run.

  Example:

  bin/yarn-session.sh
  bin/flink run examples/streaming/WindowJoin.jar

• You can use -yz to specify a ZooKeeper NameSpace when using flink run -m yarn-cluster to start a cluster.
• A NameSpace cannot be shared by multiple clusters.
• If you use -z to specify a ZooKeeper NameSpace when starting a cluster or submitting a job, you need to use -z again to specify the NameSpace when deleting, stopping, or querying the job or triggering the savepoint.