Help Center>
Distributed Cache Service>
FAQs>
Redis Usage>
Why Does It Take a Long Time to Start a Cluster DCS Instance?
Updated on 2022-08-10 GMT+08:00
Why Does It Take a Long Time to Start a Cluster DCS Instance?
Possible cause: When a cluster instance is started, status and data are synchronized between the nodes of the instance. If a large amount of data is continuously written into the instance before the synchronization is complete, the synchronization will be prolonged and the instance remains in the Starting state. After the synchronization is complete, the instance enters the Running state.
Solution: Start writing data to an instance only after the instance has been started.
Parent topic: Redis Usage
Redis Usage FAQs
- Can I Change the CPU Architecture?
- Can I Change the AZ for an Instance?
- Can I Change the VPC and Subnet for a DCS Redis Instance?
- Can I Customize or Change the Port for Accessing a DCS Instance?
- Can I Modify the Connection Addresses for Accessing a DCS Instance?
- Why Do I Fail to Delete an Instance?
- Why Does It Take a Long Time to Start a Cluster DCS Instance?
- What Should I Do If an Error Occurs in redis_exporter?
- What Is Reserved Memory? How Do I Configure Reserved Memory?
- Why Is Available Memory Smaller Than Instance Cache Size?
- Why Is Redisson Distributed Lock Not Supported by DCS Proxy Cluster Redis 3.0 Instances?
- Does DCS for Redis Provide Backend Management Software?
- Can I Recover Deleted Data of a DCS Instance?
- Why Is Available Memory of Unused DCS Instances Less Than Total Memory and Why Is Memory Usage of Unused DCS Instances Greater Than Zero?
- How Do I Estimate Redis Memory Usage?
- Why Is the Capacity or Performance of a Shard of a Redis Cluster Instance Overloaded When That of the Instance Is Still Below the Bottleneck?
- Why Does an OOM Error Occur During a Redis Connection?
- What Clients Can I Use for Redis Cluster in Different Programming Languages?
- Why Do I Need to Configure Timeout for Redis Cluster?
- Why Am I Seeing a Timeout Error When Reading Data from Redis?
- Explaining and Using Hash Tags
- Why Does a Key Disappear in Redis?
- Will Cached Data Be Retained After an Instance Is Restarted?
- How Do I Know Whether an Instance Is Single-DB or Multi-DB?
- What Are the Constraints on Implementing Multi-DB on a Proxy Cluster Instance?
- How Do I Buy a Multi-DB Proxy Cluster Instance?
Feedback
Was this page helpful?
Provide feedbackThank you very much for your feedback. We will continue working to improve the documentation.See the reply and handling status in My Cloud VOC.
The system is busy. Please try again later.
For any further questions, feel free to contact us through the chatbot.
Chatbotmore
