Updated on 2026-10-26 GMT+08:00

Network Proxy

If you are using an enterprise network, you might see a prompt indicating that the model failed to be loaded and cannot be used. If this problem occurs, you can configure a network proxy by referring to this section, restart the tool, and then use CodeArts Agent IDE.

Setting a Network Proxy

  1. Click in the upper right corner to open the global setting page.
  2. Choose General > Preference Settings, and click Configure next to Editor.
  3. On the settings page of the editor, search for proxy, click Proxy, and configure the proxy information by referring to Table 1.

    After the connection check in step 5 succeeds, continue with the remaining parameter configuration.

    Figure 1 Setting the proxy

    Table 1 Setting proxy parameters

    Parameter

    Description

    Example

    Http: No Proxy

    Specifies the domain names, IP addresses, or IP address ranges that the IDE accesses directly, without going through the HTTP/HTTPS proxy.

    Supported types:

    • IP addresses (IPv4/IPv6)
    • Domain names (supporting all domain name suffixes, such as .cn and .com)
    • Wildcard domain names (matching the main domain and all its subdomains)

    Separate multiple entries with commas (,). Do not add spaces before or after the commas.

    *.company.com,api.codearts.cn,127.0.0.1

    *.company.com matches the main domain and all its subdomains, so access to them bypasses the proxy.

    Http: Proxy

    Specifies the proxy address that the IDE uses. If you enter an address, the IDE uses that proxy. If you leave it blank, the IDE inherits the proxy from the http_proxy and https_proxy environment variables.

    http://127.0.0.1:7890

    Http: Proxy Support

    Specifies whether to use the proxy configuration in the Http: Proxy parameter.

    The default value is override.

    override

    Http: Proxy Username

    Specifies the username for logging in to the proxy that requires authentication.

    zhangsan

    Http: Proxy User Password

    Specifies the password for logging in to the proxy that requires authentication. This parameter is used together with Http: Proxy Username.

    CAUTION:

    If your Proxy User Password contains special characters such as @ or %, you must URL-encode them before entering the password. Otherwise, the proxy configuration may be invalid.

    For example, if your password is Admin%@test, the password after URL encoding is Admin%25%40test. For details about URL encoding for common special characters, see Table 2.

    Proxy@Pass123

    Table 2 URL encoding for common characters

    Character

    URL Encoded Value

    @

    %40

    %

    %25

    &

    %26

    =

    %3D

    +

    %2B

    Space

    %20

    #

    %23

    /

    %2F