Updated on 2024-01-25 GMT+08:00

ALM-135463087 hwIfMonitorOutputRateRising

Description

Interface output flow bandwidth usage exceeded the trap threshold. (Interface=[IfIndex], BandWidthUsage=[hwIfMonitorOutputRatePercentage], TrapThreshold=[hwIfMonitorOutputRateThreshold], InterfaceName=[InterfaceName])

This object indicates that an alarm is generated when the ratio of the traffic sent by an interface to the total bandwidth of the interface exceeds the threshold.

Attribute

AlarmID

Alarm OID

Alarm Severity

Alarm Type

135463087

1.3.6.1.4.1.2011.5.25.41.4.7

Warning

Processing error alarm

Parameters

Parameter

Description

IfIndex

Interface index

hwIfMonitorOutputRatePercentage

Output traffic statistics.

hwIfMonitorOutputRateThreshold

Output traffic alarm threshold.

InterfaceName

Interface name.

Impact on the System

When the traffic is close to 100% of the bandwidth, delay or packet loss may occur.

Possible Causes

The rate of traffic sent by the interface was too large.

Procedure

1. Run the display this interface command in the interface view to check whether the traffic threshold is too low.Determine the alarm threshold based on service requirements.

  • If yes, go to step 2.
  • If not, go to Step 3.

2. Run the trap-threshold output-rate bandwidth-in-use command in the interface view to reconfigure the alarm threshold. Then check whether the alarm is cleared.

  • If yes, go to Step 4.
  • If not, go to Step 3.

3. Collect alarm and configuration information, and contact technical support personnel.

4. End.

Related Information

None.